







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
James Hardie Roofing: The North Miami Owner’s Guide
We install James Hardie-compatible roofing for North Miami homeowners, and most roof repairs here run $470 to $2,125, while a full roof replacement runs $9,440 to $23,600. James Hardie is best known for fiber cement siding, so if your roofer or inspector referred to “James Hardie roofing” on your home, the reference usually means HardiePlank, HardieShingle, or HardiePanel cladding tied into the roof edge, flashing, or soffit line. Penhallow Remodeling North Miami is an independent service provider and is not affiliated with James Hardie.
Owners usually find the problem the same way: a brown water stain on a ceiling near an exterior wall after a summer storm, or cracked and chalky cladding under the eaves. In North Miami, that picture points to wind-driven rain getting behind the roof-to-wall junction, not to the shingles.
Key Takeaways
- Roof repair in North Miami: $470 to $2,125 installed.
- Full roof replacement: $9,440 to $23,600.
- Most failures we see are flashing and cladding, not the roof deck.
- Written price before any work starts, and a live person answers the phone 24/7.
Which James Hardie Models This Applies To

James Hardie fiber cement comes in three product lines that touch your roof system, and each has its own failure pattern:
- HardiePlank lap siding – the horizontal boards most North Miami homes have. The failure point is the bottom course where it meets the roof edge or a lower roofline.
- HardieShingle – the shake-look panels, often used on gables. These are the ones that crack first in hurricane-season wind.
- HardiePanel vertical siding and HardieSoffit – the underside and gable trim, where water hides and efflorescence (the white powder that signals moisture in cement board) shows up.
To match the part correctly, find the product label on the back of an exposed board, or measure the reveal width and thickness. HardiePlank comes in specific nominal thicknesses (about 5/16 inch for the standard line), and an aftermarket cement board of a different thickness will not line up with your existing trim or color coat. That measurement is the compatibility gotcha most DIY shoppers miss.
OEM vs aftermarket: James Hardie board carries a manufacturer warranty that’s tied to installation to their published spec, including fastener type and clearance above the roof surface. A generic cement board at the home center can cost less, but it typically voids that coverage and may not match the color or profile. For a repair near the roofline, we generally recommend matching the original Hardie product so your warranty stays intact. We install roofing sourced from recognized trade brands, and we also work with KraftMaid, Cambria, and Silestone on interior projects.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your James Hardie Roofing Is Failing
Here’s what we actually look for on a North Miami roof inspection:
- Crumbling or soft cladding at the bottom edge. Water wicks up from the roof-to-wall joint and the cement board loses its structure. Once it’s soft to the touch, the board is done.
- Water stains on interior ceilings near exterior walls. That’s usually failed step flashing or a lifted piece of cladding letting rain in behind the roof edge, not a hole in the shingles.
- Efflorescence and chalky white powder. A sign of trapped moisture behind the board. In our humid climate, it also points to the wrong fastener or a missing drainage plane.
- Lifted, cracked, or missing HardieShingle panels on a gable. Wind-driven rain and storm gusts peel these first because they take the most exposure.
- Paint peeling in sheets rather than chalking off. On fiber cement, that means moisture is coming from behind the board, not from the sun.
One lifespan reality worth stating plainly: even correctly installed James Hardie cladding needs its caulk joints and paint touched up on a schedule, and in Florida’s sun and humidity that schedule is shorter than the national guidance suggests. Neglect the joints and the board fails at the seams first.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For North Miami, these are the installed ranges we work from, parts and labor together:
| Job | Installed range |
|---|---|
| Roof repair / small cladding-and-flashing fix | $470 – $2,125 |
| Tile roof repair (if your roof is tile) | $710 – $2,950 |
| Full roof replacement | $9,440 – $23,600 |
| Metal roof installation | $17,700 – $47,200 |
What moves the number: the height and pitch (two-story gables take more labor), how many courses of cladding are damaged, whether the flashing behind the wall needs rebuilding, and whether you’re matching an original Hardie color or repainting a section. We give a written line-item price before any work starts, so the number on day one is the number on the invoice. Every repair comes with our written guarantee, and the 365-Day Done Right Promise backs it: if it fails inside that period, we come back and fix it at no charge.
DIY or Call Us?
You can safely check a few things: look for stains on interior ceilings, feel the bottom edge of your cladding for softness, and photograph any cracks from the ground with binoculars. What you shouldn’t do yourself is get up on the roof to re-flash the joint or replace cladding near the roofline. North Miami roofs are often two-story and steep, and the fix depends on getting the flashing and the drainage plane right the first time. A board slapped back in without the right layering will leak again within one rainy season, and a fall from a North Miami roof is a serious injury.
The safe answer is a professional inspection with a written price. Call Penhallow Remodeling North Miami at (888) 255-7411 and we’ll walk the roof, tell you what actually failed, and put the number in writing before anyone picks up a tool. A live person answers, day or night, and our technicians are background-checked and arrive in uniform.
FAQs

Expect roughly 20 to 30 years for the board itself when it’s installed to spec and the caulk joints and paint are maintained, but in South Florida’s sun and humidity, expect to recaulk seams and touch up paint on a shorter cycle than the national guidance suggests. Sea air and storm-driven rain shorten that timeline further. Call (888) 255-7411 for an inspection and a written quote.
Often, yes. If the damage is limited to a few courses of cladding and a section of flashing, we can usually patch it and keep the rest, keeping the repair in the $470 to $2,125 range. If moisture has spread behind several courses or the deck is soft underneath, replacement of a larger section makes more sense. The right call comes from looking at it, not guessing.
A focused repair on a few courses and the flashing is typically a one- to two-day job once the matched Hardie material is on site. A larger section or full replacement runs longer and depends on the material lead time. Either way, you get a written time window with the written price.
We match the original James Hardie product line, thickness, and profile, then order it through trade suppliers so the manufacturer warranty stays valid. If the exact color or profile is discontinued, we’ll tell you before we start and lay out the closest match and what it means for the finish. Call (888) 255-7411 for a free estimate.
Written by the team at Penhallow Remodeling North Miami, serving North Miami and nearby areas.












