







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
James Hardie Bathroom Remodeling: The North Miami Owner’s Guide
James Hardie bathroom remodeling in North Miami typically runs $10,620 to $33,040 installed, and that range covers the full job: cement board substrate, waterproofing, tile, fixtures and finish. We install James Hardie tile backer and fiber-cement bathroom systems across North Miami, and we give you a written price before any demo starts. Penhallow Remodeling North Miami is an independent remodeling company, not affiliated with James Hardie.
Most owners find out something failed the same way. A tile pops loose and the thin-set behind it crumbles. A grout line near the tub goes dark and stays dark after scrubbing. Water stains creep along the baseboard on the bedroom side of the shared wall. The board behind the tile looked fine at the surface, and the failure was underneath the whole time. In a climate that averages high humidity nine months of the year, that’s the pattern we see most in North Miami.
Key Takeaways
- Installed James Hardie bathroom remodeling in North Miami: $10,620 to $33,040.
- HardieBacker boards are 1/4-inch for floors and 1/2-inch for walls; both use the same screw pattern but not the same spacing.
- North Miami’s humidity and salt air punish any bathroom that wasn’t waterproofed behind the tile.
- We give a written price up front and back every job with our 365-Day Done Right Promise.
Which James Hardie Models This Applies To

James Hardie makes two products that matter in a bathroom remodel. HardieBacker cement board is the substrate – the moisture-resistant layer that goes behind your tile – sold in 1/4-inch thickness for floors and 1/2-inch for walls. HardiePanel fiber-cement sheet and the HardiePlank lap siding lines are exterior products, and they only come into play if your North Miami remodel touches an exterior wall or a screened porch conversion.
Identify the right board by reading the stamp printed on the face of the panel, not the packaging. HardieBacker carries a printed label with the thickness and a lot code; if a previous crew installed a no-name board, you often can’t confirm what’s behind the tile until demo day.
The OEM-versus-aftermarket decision here is real. Generic fiber-cement boards can run thinner, absorb moisture at a different rate and handle a different screw pattern than HardieBacker, especially at the 1/4-inch floor grade. We use James Hardie board when the job calls for it because the product carries its own manufacturer warranty alongside ours. For cabinetry and tops, we also source KraftMaid, Cambria and Silestone.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your James Hardie Bathroom Remodeling Is Failing
- Hollow or loose tiles. Tap a tile with a coin handle. A sharp, hollow sound means the thin-set lost its bond to the board, usually because moisture got behind the tile and the board absorbed it.
- Dark grout lines near the tub or shower floor. Grout that stays dark 24 hours after cleaning is wicking water. If it’s happening on freshly installed tile, the waterproofing layer was skipped or shorted.
- Soft spots underfoot. A floor that gives slightly near the toilet flange or shower curb points to a compromised board and a slow leak beneath it.
- Water stains on an adjacent wall or ceiling. This is the tell that the shower pan or the board seam failed and water traveled into the framing.
- Recurring mold in the same corner. Mold that returns after every cleaning means the substrate is holding moisture, not just the air. North Miami’s year-round humidity speeds this up.
Two of these together is a repairable situation. Three or more usually means the board and waterproofing need to come out and go back in correctly.
Replacement Cost & What’s Included

James Hardie bathroom remodeling in North Miami runs $10,620 to $33,040. A small bathroom remodel lands in the $5,900 to $14,160 range when the footprint stays put and the board and tile are replaced without moving plumbing.
What drives the number up:
- Waterproofing scope. Membranes and vapor barriers behind the board are labor, not parts, and they’re the step cheap bids skip.
- Fixture line. Standard Moen and Delta fixtures sit at the bottom of the range; Kohler and Grohe sit higher.
- Plumbing relocation. Moving a drain or supply line behind the wall turns a board-and-tile job into a rough-in job.
- Board grade. Floor-grade 1/4-inch board with proper thinset and screw spacing costs more in labor than a thin hardboard substitute.
Every quote is itemized parts and labor, in writing, before work starts. Our written guarantee covers the installation, and the 365-Day Done Right Promise means if the work fails inside the first year, we come back and fix it at no charge.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check a few things: tap the tiles for hollow spots, look for water stains on the back side of the shared wall, and read the board label if there’s an exposed edge. Pulling a shower valve, cutting out cement board that may have water behind it, and re-sealing a shower pan are different. Wrong call there means a leak that runs into a wall cavity for months before anyone notices.
If you’re seeing soft spots or water stains, stop here and call us at (888) 255-7411. A live person answers 24/7, and the visit comes with a written price before anything is opened up. Our technicians have up to 22 years of experience and arrive background-checked and in uniform.
FAQs

A correctly installed HardieBacker board and tile system lasts 20 to 30 years in a North Miami bathroom, provided the waterproofing layer was installed and the ventilation is adequate. The board itself is rated to hold up to moisture; what fails earlier is the thin-set and grout at seams where water sits. Call (888) 255-7411 for a free estimate.
Sometimes, but only when the failure is limited to one section. A single loose tile over sound board is a patch. A soft shower curb or water staining on the far side of the wall means the failure is under the whole shower, and patching won’t hold. We’ll tell you honestly which one you have before any work starts. Call (888) 255-7411 to schedule your free estimate.
A tile and board replacement in a standard North Miami bathroom takes 7 to 10 working days, including demo, waterproofing cure time, tile and grout. A full gut with plumbing or vanity work runs 3 to 4 weeks. You get a defined arrival window and a written schedule up front. Call (888) 255-7411 for an exact range.
We order James Hardie board directly through the brand’s distribution network and match the correct thickness to the job – 1/4-inch for floors, 1/2-inch for walls. If the job needs a specific model or product line, we confirm the stamp and thickness before it ships. No stock on a truck, no substitutes. Call (888) 255-7411 to talk through your project.
Get a Written Price Before Demo Day
If your North Miami bathroom is showing water stains, loose tile or a floor that feels soft, the longer it sits, the bigger the repair gets. Penhallow Remodeling North Miami gives you a written, itemized price before any work starts, backed by our 365-Day Done Right Promise. Call (888) 255-7411 for a free estimate – a live person answers, and we’ll give you a real number before we pick up a tool.
Written by the team at Penhallow Remodeling North Miami, serving North Miami and nearby areas.












